What this blog covers
Choose a post using the questions below. Each article explains one specific question and the conditions that change the answer.
- Press brake tonnage explained
Why does the required bending force change with thickness, bend length, V opening or tensile strength?
- Bend allowance vs bend deduction
Should you use bend allowance or bend deduction for the flat length, and how do you keep dimension conventions consistent?
- Sheet metal gauge and weight
How does gauge relate to millimetre thickness and weight per square metre, and how do you avoid using the wrong material system?
- Springback and angle compensation
Why does the angle change after a material change, and why does compensation need measurement?
- Laser cutting cost per metre
Why is the hourly rate alone insufficient to compare cutting cost per metre?
- GB 17120-2025: edition and procurement references
How do you check the edition, effective date and machine-specific references before updating purchasing or acceptance documents?
- What an automatic bending line patent actually claims
What does CN109550818B require in claim 1, what do the dependent claims add, and what does the document leave out?
- Four patents, one direction: where bending automation moves
What four filings from 2017 to 2023 show about where the value in bending automation has migrated, and what a buyer should ask.
- What a three-point bending experiment shows about springback prediction
Measured springback and load on clad AW-2024: which model wins, how much a coating changes the error, and what that means for the ram-depth table.
- OSHA's press standard excludes press brakes
The mechanical power press rule removes press brakes from scope in (a)(5). What actually applies, and the sentence to put on a quotation.
- A tool magazine that moves a whole set
How US11745241B2 transfers a complete tool set from storage to the tool holders, and what a production changeover test must still measure.
- The reverse bend is a collision problem first
Why EP2711102B1 rotates a panel-bender blade about its free end, and how the motion clears reverse bends and tall flanges.
- This patent puts the angle sensor on the workpiece
How US9778013B2 uses gyroscopes and stationary accelerometer readings to measure sheet rotation and drive a correction.
- Press Brake Backgauge: Axes, Accuracy and Selection
Why does the same program give a different flange dimension, and which axis setting decides where the bend line falls?
- Press Brake Safety Devices: Guards, Light Curtains and Lasers
Light curtain, laser protection, two-hand control, guard: what does each device prevent, and what does it not cover?
- Press Brake Maintenance: Checks, Intervals and Records
Which maintenance work belongs before use and which after isolation, and why intervals, lubricants and limits come from the manual of that machine.
- Used Press Brake Buying Guide: Inspection and Total Cost
What a buyer can confirm from documents and from outside the machine, and which checks belong to a qualified person with the machine isolated.
How to read a post
Use the stated material, geometry and process assumptions when applying an example. For a production part, check those inputs against the actual tooling, setup and measurements.
Where to go next
Choose the next resource for your task; you do not need to read every article first.
Sheet metal calculators
Enter your inputs for initial results on weight, bend deduction, press brake tonnage or V-die opening.Knowledge base
Find background and diagnostic explanations for material, process, tooling and quality questions.Standards hub
Check edition status, dates and replacement facts for the standards cited across the site.Buying and acceptance guides
Use the guides to decide whether your next task is press brake selection, automation assessment, trial planning or machine acceptance.
Once you have decided to compare equipment and defined the part and process requirements, view the press brake range for the available product families.