Applications
Sheet Metal Bending Applications by Industry
Find a starting point for your part: HVAC duct edges and joints, elevator cabin panels and door frames, or electrical cabinet body-and-door interfaces. Follow the closest forming and assembly problem, then check the route against your drawing.
A seam, a visible face or a mating opening can determine which application page to read first. A long, thin galvanized duct part calls for checks of its material and unloaded geometry; a cabin panel also calls for a review of the long bend and visible face; cabinet returns call for short-flange, assembly and batch checks. Unloaded geometry means the angles and dimensions measured after the load is removed. These are starting points for reviewing a drawing, rather than a fixed forming route for every part in an industry.
The pages below are starting points for sheet metal fabrication applications; use them when the industry name is clearer than the machine name. For sheet metal bending by industry, start with the closest workpiece and interface; for industrial sheet metal fabrication, the same part-first review applies: identify the material, the longest bend, the visible face and the assembly interface before comparing equipment.
Choose the closest part and interface
| Application | Typical parts | Questions to review first |
|---|---|---|
| HVAC sheet metal fabrication | Duct flanges, damper frames, casing panels | For long, thin parts, identify the material and check the unloaded geometry; distinguish a flange bend from the joint and sealing operations. |
| Elevator sheet metal bending | Cabin panels, door frames, sill supports | Review the long bend and visible face of panels, the mating datums of door frames and the drawing requirements for supports. |
| Electrical cabinet sheet metal bending | Enclosure bodies, doors, mounting plates | Check short returns, body-and-door datums, hole, hinge and seal interfaces, and consistency across the batch. |
Continue with HVAC for duct edges, joint details and the forming sequence.
Continue with Elevator for visible panels, door-frame returns and mating datums.
Continue with Electrical cabinet for enclosure returns and body-and-door interfaces.
How to read an application page
- Identify the material grade, actual thickness and part section; use these to review the radius, tooling and surface risk.
- Mark short returns, the longest bend, the visible face and mating datums before reviewing the difficult bends.
- Check access for the next operation and removal of the formed part. Then carry the requirements into equipment questions about usable bending length, force, backgauge travel and deflection compensation.
- An application page does not replace a drawing review. Review bend lines, tolerances and the order of operations against the drawing.
When the part does not fit one industry
A cabinet bracket may share a bend problem with an elevator bracket, and a casing panel may share a springback question with a duct part. If a part resembles more than one category, start with the interface that needs review: a seam, a visible face or a mating opening. Keep the material, dimensions, tolerances and sequence specific to the actual drawing; send the drawing when the category is unclear.
FAQ
What industries use sheet metal bending?
The pages in this directory cover HVAC, elevator and electrical cabinet work because those industries show distinct workpiece and interface problems. Other industries can use the same part-first review: material, longest bend, visible face and assembly interface.
Which machine for HVAC sheet metal?
A press brake is a candidate route for flanges, frame bars and brackets; a panel bender can suit repetitive flat panels; a shear prepares straight blanks and a roller forms curved transitions. The workpiece, not the industry name, decides the route.
Which machine for electrical cabinet sheet metal?
A press brake handles short flanges and returns; a panel bender can be a candidate for repetitive enclosure panels; V-grooving may prepare a bend line where the drawing requires it. Check the body-and-door datums and assembly interfaces before choosing.
Can you supply a complete line for one industry?
The site publishes forming machines, not a complete industry line. Feeding, joining, coating and assembly equipment remain separate scope items and must be reviewed in the part route.
Related pages
Equipment and quotations
Contact JS Ragos for machine models, configurations and quotations.
Get a quote