What to bring to the selection
Start with the material grade and condition, actual thickness, target inside radius and angle, shortest flange and bend sequence. For return-flange clearance, compare straight and gooseneck punches. For radius and flange support, compare V openings and the usable groove length. Match both tools to the holder and machine interfaces and check their ratings for the actual contact length.
Tooling comparison
| Tooling topic | What it solves | Typical use | Main trade-off |
|---|---|---|---|
| V-die opening | Influences the inside radius and the minimum flange in air bending; the page also covers multi-V dies | Air bending mild steel and stainless steel on a press brake | A larger V opening widens the inside radius and raises the minimum flange |
| Punch | Transmits ram force into the sheet and sets the bend line and tip form; the page also covers gooseneck punches | General air bending and 90-degree bends | Punch height and tip geometry limit clearance for return flanges and short flanges |
The tooling comparison is not a machine specification. Use the V-die opening calculator for a preliminary opening, inside radius range and minimum flange estimate, not a rule or a substitute for drawing and material requirements.
Check the candidate combination together
Check clearance, sheet support, interfaces and rated loading together for the proposed combination. A change to either tool can affect the other checks.
- Material and target geometry: check the grade, condition, actual thickness, required radius, angle and flange dimensions together.
- Support, positioning and clearance: check every stage of the bend sequence, including return flanges and removal of the part.
- Tools, holders and adapters: verify interfaces against the actual component documents. Compare required and rated loads in the same units for the actual loaded length; check machine total force and local or concentrated load limits separately.
- Long bends: check ram and bed deflection with the machine and tooling combination. Crowning addresses deflection, not springback.
Two tooling pages
Open the guide for the constraint you need to resolve first. A short flange can require both a support check at the die and a clearance check at the punch.
V-die opening
Start here when inside radius, opening or support governs. Bring material grade/condition, thickness, radius/angle, shortest flange and bend length; continue with opening, support and multi-V conditions.Punch
Start here when return flanges, neck or bend-sequence clearance governs. Bring the section, sequence, return-flange height, candidate punch and holder/adapter interface drawings; continue with tip condition and geometry, height, gooseneck clearance and actual rated limits.
Confirm the selected tools
Confirm interfaces and rated loading against the actual tool, holder and machine documents. Use a representative trial bend to check the formed radius and part geometry; keep the verified combination with the job setup.