What this branch covers
Use general tolerances to interpret drawing requirements, the defect atlas to investigate visible symptoms, and inspection to understand flatness and Ra measurements. Choose the page for the question you need to answer now.
Three quality pages
Each page covers the purpose of the check, the measurement that matters, the common mistakes and the link to the applicable standard or process page.
Tolerances
GB/T 1804 classes and drawing notes; the scope of GB/T 1804 and ISO 2768, without a numeric equivalence table.Inspection: flatness and surface finish
Flatness and Ra on the specified surface: measurement conditions and suggested record fields, not a completed inspection report. Straightedge and feeler-gauge screening does not automatically equal the specified flatness evaluation.Defect atlas
Burr, dross, angle drift, bend cracking, oil-canning and weld distortion: possible causes and checks for each.
Quality comparison
| Quality topic | Question it answers | What to measure | Where it is used |
|---|---|---|---|
| Tolerances | How much variation the drawing allows | Dimensions and angles against the drawing | Incoming, in-process and final inspection |
| Inspection | How far the part departs from a plane and how rough the surface is | Flatness under a straightedge or on a surface plate; Ra from the drawing | Cut, formed and welded parts, and visible or functional surfaces |
| Defect atlas | What went wrong and which check confirms it | The visible symptom plus a targeted check | Troubleshooting at the bench |
The table connects the question to a suitable type of check. Establish the actual limit from the drawing, customer requirement or applicable standard before assessing the result.
Straightedge and feeler-gauge checks are workshop screening, not automatically the specified flatness evaluation. Agree the method for flatness and Ra on the specified surface.
Reading the comparison
- Start with the drawing: the tolerance note, the flatness callout and the finish requirement decide what has to be checked.
- Separate the part check from the machine check: tolerances and finish are measured on the part, while machine acceptance is handled in the guide.
- Use the defect atlas when a check fails, so the symptom is tied to a likely cause instead of a guess.
- Cite the standard number and edition whenever a requirement is quoted; do not rely on a remembered class.
For whole-machine handover checks, use the machine acceptance guide. Part measurement records cannot replace machine acceptance.
To agree part checks, limits, methods, sample count, frequency and records before work starts, use the proposed inspection plan. It is for discussion and agreement between both parties; it does not prove completed factory checks or certification.
The inspection page suggests record fields. A real report also needs the order and part or batch identity, actual measurement conditions and original readings; a blank template cannot replace it.
Find the inspection requirement
Keep the required feature, tolerance or quality characteristic with the drawing revision and agreed inspection method. Use the cited standard and edition for the applicable numerical limits.
For thermal cut-edge classification, see ISO 9013 cut quality; it is not a universal criterion for every edge or process.