Start with the change the part needs
To separate a flat blank, compare laser cutting for profiles and holes with shearing for straight cuts. To form it, compare press-brake bending for angles and flanges with rolling for continuous curves. To join separate pieces permanently, review welding. These five operations can form a sequence; choosing one does not replace the others, and this directory does not cover every fabrication process.
Compare purpose, conditions and results
| Process | Intended result | Capacity conditions | Result to inspect |
|---|---|---|---|
| Laser cutting | Profiles, holes and contours cut from flat sheet | Material/model specific | Classified by ISO 9013; dross and burr are the usual defects |
| Bending | Angles and flanges formed on a press brake | Material/model specific | No cut edge; bend radius, springback and die marks set the result |
| Shearing | Straight cuts, blanks and strip from flat sheet | Material/model specific | Straight edge with burr; blade clearance controls the finish |
| Rolling | Cylinders, arcs and curved panels | Material/model specific | No cut edge; curvature, ovality and flat ends set the result |
| Welding | Permanent joining of sheet and formed parts | Material/model specific | Joined edge with a heat-affected zone; distortion is the main risk |
Check usable capacity for the actual material, equipment, tooling and part dimensions. Confirm the proposed route with machine specifications and a representative trial part.
Use the conditions to narrow the choice
- Match the geometry first: profiles and holes, straight blanks, angles and flanges, continuous curves, or a permanent joint.
- Then check thickness and material strength together. Higher-strength steel can increase forming force and springback.
- Define the result for the operation: a cut edge, a formed angle or curve, or a joint. These are not interchangeable quality measures.
For thermal-cut edges, check the applicable ISO 9013 classification with the material and thickness. It is not a common acceptance criterion for bending, rolling and welding.
Five process pages: what to check next
Choose the page that answers the next unresolved process question; the summaries below identify what to check there.
Laser cutting
Compare gas routes and the edge requirement, then inspect dross, burr and the heat-affected zone. Material identity alone does not fix the assist gas.Bending
Compare air bending, bottoming and coining; check finished radius, springback, tooling constraints and blank-length preparation.Shearing
Check straight-cut limits, actual material, thickness and cut length, and whether blade clearance means single-side or total clearance.Rolling
Check the minimum finished part diameter for the material, thickness and width, then review pre-bending, flat ends and springback.Welding
Check joint requirements, preparation and distortion. Intermittent welds cannot simply replace a specified continuous or leak-tight joint.
Review the sequence together
A hole close to a bend can distort even when it was cut first. Check its position against the bend geometry rather than assuming that cutting before bending resolves it. Welding after forming can move an angle or radius; forming across a welded seam may damage the joint. Review feature positions, access and final drawing dimensions together before fixing the sequence.
Capacity and data boundaries
Capacity depends on the actual material, equipment, tooling and process conditions. Gas supply and cut-quality classification matter for the relevant cutting route, not every operation. Production rates, prices and delivery times are commercial questions and are not stated here.